User`s guide

Using the Administrative Interface 7-11
System Commands
For example:
00-00-F8-00-01-23 : public : private
set-fg-parm
Usage:
set-fg-param <dest> <source> <fill_byte> <length>
This command sets the frame generator parameters. The
dest
and
source
parameters
are dash-separated hardware addresses in hexadecimal. The
fill_byte
parameter is a
single byte used to fill the entire packet except for the first 12 bytes. The
length
parameter is the total length of the packet excluding CRC.
start-fg
Usage:
start-fg <dport> <count> <rate>
This command starts frame generation. The
dport
parameter is a hexadecimal bitmap
of which ports to generate traffic on. For example, a
dport
of 3E will send frames to
ports 2, 3, 4, 5, 6. The
count
parameter specifies the number of frames to send on each
interface. A count of 0 specifies an infinite number of packets. The
rate
parameter
specifies the number of packets per second to generate.
stop-fg
This command stops the Ethernet frame generator.
get-stst-level
This command shows the self-test level of the switch.
set-stst-level
Usage:
set-stst-level <level>
This command sets the self-test level of the switch. There are four levels of self-test:
none, short, long, and diagnostics. The self-test level is stored in NVRAM.
The default self-test level is short. In this mode, this power-up sequence is followed:
The OS/bootloader boots out of the ROM bank. The checksum of the SNMP software
flash bank is verified for consistency. The bootloader prints a # character to the serial
console. It then waits 5 seconds for a download command from a PC running the