User`s guide

System Commands
7-10 Using the Administrative Interface
Sets the name of the file downloaded by TFTP. This name must match the name of the
agent software file on the TFTP server. When TFTP is used, the per-packet
retransmission timeout value on the server must be increased to 10 seconds because
the SNMP Agent must first erase its flash EEPROM, which takes about 30 seconds.
get-rsw-file
This command retrieves the SNMP Agent software’s remote filename.
set-rsw-file
Usage:
set-rsw-file <remote_filename>
This command sets the SNMP Agent software’s remote filename for download. The
download is initiated with the sw-dnld command.
get-tftp-srvr
This command retrieves the TFTP download server’s IP address.
set-tftp-srvr
Usage:
set-tftp-srvr <ip_address>
This command sets the TFTP download server’s IP address.
sw-dnld
This command starts the SNMP software download from the predefined server.
get-par-file
This command retrieves the SNMP Agent parameters filename.
set-par-file
Usage:
set-par-file <filename>
Sets the name of the SNMP Agent parameters file downloaded by BootP. This
filename must match the name of the parameters file on the BootP server. The format
of the parameters file is:
<switch_hardware_address> : <read_comm> : <write_comm>