User`s guide

Using the Administrative Interface 7-9
System Commands
warm-reset
The warm-reset command resets the SNMP Agent software without resetting the
switch. Nevertheless, the switch configuration is changed according to the values
stored in the NVRAM. This command permits you to refresh the switch configuration
after a change of the NVRAM parameters. The statistics counters are also reset by the
warm-reset command.
cold-reset
This command causes the switch to cold-reset. Cold reset is equivalent to power
cycling the switch.
get-last-err
This command retrieves the most recent system failure for diagnostic purposes.
SYS_console> get-last-err
System information since the last hardware reset
------------------------------------------------
Software resets number : 0
The system never encountered a fatal error
SYS_console>
init-nvram
This command resets the nonvolatile RAM on the SNMP Agent to default values.
set-line-slip
Usage:
set-line-slip {9600|19200|38400}
This command changes the console serial port to SLIP mode for out of band SNMP
management. The argument to the command is the new baud rate for the interface.
The SLIP interface can be configured using the set-slip-cfg console command. You
can return the serial port to console mode by pressing <Return> three times in a row.
get-sw-file
This command retrieves the SNMP Agent software file name.
set-sw-file
Usage:
set-sw-file <filename>