User guide

Page 2
You may receive an error when you try to review the “Read Me” file on installing the
AdobePS 4.1.1 printer driver. The README.WRI file may not be present on the CD.
You can obtain this important file from Digital's Printing Systems Business Infocenter at:
http://www.printers.digital.com/
• Upgraded versions of the utilities on the User Software CD
Be sure to install the v2.1 utilities on all client computers printing to the Colorwriter.
Supported Platforms
The following chart shows the platforms that are supported for Colorwriter printing and
utilities in version 2.1, and the network type(s) that these platforms support.
Removing the oil when moving the printer
Before you move the printer, it is extremely important to follow these procedures to remove
oil from the fixing unit.
To remove the fixing unit:
1. Open the front door and remove the oil bottle.
2. Open the feeder door.
3. Open the fixing unit cover.
4. Remove the strap on the right side by pulling down the top tab and then lifting the strap
from the slot in the engine chassis.
5. Slide the door to the left off the hinges.
6. Loosen the two large screws near the door hinges, pull the black handles of the fixing unit
toward you, until it slides out on a rack.
7. Grasp the fixing unit with your hands inside the green handles on the fixing unit, and lift
the fixing unit straight up and out. Be sure to keep the fixing unit level while you lift it.
N
OTE
:
Since there is a possibility of spilling oil when removing the fixing unit, lift it out
slowly and evenly. If you spill oil, wipe it up with a towel.
8. Place the fixing unit on paper that is on a level surface.
To remove oil from the fixing unit:
1. Remove the cover and cleaning cap of the oil storage bottle.
2. Withdraw the oil from within the bottle case with the oil removing tool that comes with the
printer.
Platform: Printing: Utilities:
Mac OS AppleTalk AppleTalk
Windows 3.x IPX not supported
Windows NT TCP/IP, IPX, or AppleTalk TCP/IP or IPX/SPX
Windows 95 IPX TCP/IP or IPX/SPX