Technical data

14.2.9 Job Log and Job Trailer Pages Sent to Specified Output Tray
The job log and job trailer pages, if any, are now normally directed to the output
tray you specified with the OUTPUT_TRAY parameter. However, if DCPS reports
a NOOUTTRAY, OUTTRAYNOTAVL, or OUTTRAYMISMATCH error when
initially attempting to select the specified output tray, the job log and trailer
pages are instead directed to the printer’s default output tray so that you get an
indication of the problem.
In previous versions of DCPS, the job log and trailer pages were always sent to
the printer’s default output tray for non-PrintServer printers. For example, it
was previously documented that use of OUTPUT_TRAY=FACE_UP for the HP
LaserJet 4SiMX printer would not direct the trailer page to the face-up output
tray. This restriction no longer exists.
14.3 DCPS Version 1.3 Changes
14.3.1 New C6 Paper Size
DCPS now supports the C6 (326x460 mm) paper size. You can specify C6 as the
logical PAGE_SIZE value for any printer, and as the physical SHEET_SIZE value
for the LN17ps printer.
14.3.2 Device Control Modules Changed for UNRECOGNIZED Printer
The four device control modules for ‘‘unrecognized’’ printers, as well as those for
other printers, were changed. If you made any changes to previous versions of
these Compaq-supplied modules, you may need to rework your changes. See the
DECprint Supervisor for OpenVMS System Manager’s Guide and comments in
the LPS$$UNRECOGNIZED_* modules for more information.
DCPS Version 1.3 Information 14–3