Technical data

9
DCPS Version 1.6 Information
This section describes changes included in DCPS V1.6. You can find more
information for several of these changes elsewhere in these release notes.
9.1 DCPS Version 1.6 Changes
9.1.1 OpenVMS VAX V5.5-2 and V6.0 Systems Supported
DECprint Supervisor for OpenVMS is now supported on systems running
OpenVMS VAX V5.5-2 or later. DCPS V1.4 and V1.5 require a minimum
operating system version for VAX systems of OpenVMS VAX V6.1.
The DEC C/C++ Run-Time Components kit must be installed before installing
DCPS on an OpenVMS VAX V5.5-2 or V6.0 system. See the DECprint Supervisor
for OpenVMS Software Installation Guide for more information.
9.1.2 New Printer Support
DCPS V1.6 adds support for the following printers:
DIGITAL Laser Printer LNC02
DIGITAL Laser Printer LN15+
You can find more information in Chapter 4 of these release notes.
9.1.3 New Paper Sizes
DCPS supports several new paper sizes, as listed in the table below. You can
specify these sizes as the logical PAGE_SIZE value for any printer, and as the
physical SHEET_SIZE value for the LNC02 printer.
Size Name Size (mm) Size (inches)
FOOLSCAP 203 x 330 8.0 x 13.0
SPFOLIO 216 x 315 8.5 x 12.4
UKQUARTO 203 x 254 8.0 x 10.0
9.2 DCPS Version 1.6 Fixes
The following problems are fixed in DCPS V1.6.
9.2.1 Every Page Is Offset on LN40
If the Offset Stacking feature of the DIGITAL Laser Printer LN40 was enabled
from the printer’s console, DCPS jobs would print with each page offset from the
previous page. This problem is fixed, with the following restrictions:
• If a SHEET_COUNT parameter value greater than 1 is specified, job and file
separator pages are printed offset from the user job. In addition, the copies of
each page of your job are offset from the copies of the previous page.
DCPS Version 1.6 Information 9–1