Technical data

5
DCPS Version 1.8 Information
This section describes changes included in DCPS V1.8. You can find more
information for several of these changes elsewhere in these release notes.
5.1 DCPS Version 1.8 Changes
5.1.1 New Printer Support
DCPS V1.8 adds support for the following printers:
GENICOM LN21
GENICOM LN28
GENICOM LNM40
GENICOM microLaser 170
GENICOM microLaser 210
GENICOM microLaser 280
GENICOM microLaser 320
GENICOM microLaser 401
HP LaserJet 8000
Lexmark Optra S 1625
Lexmark Optra S 1855
Tektronix Phaser 780
You can find more information in Chapter 4 of these release notes.
5.1.2 Some DCPS Stapling Restrictions Removed
DCPS supports the stapling option on the LN32, LNM40, mL320 and mL401
printers.
In DCPS V1.7-1, you could not automatically staple jobs containing more than
one file. Starting with DCPS V1.8, jobs with multiple files will be automatically
stapled if requested.
In DCPS V1.7-1, you could not automatically staple PCL jobs. Starting with
DCPS V1.8, PCL files will be automatically stapled if requested. If stapling
is requested, PCL files will be translated to PostScript using the DCPS PCL4
translator, rather than being interpreted by the printer’s native PCL interpreter.
If your PCL file contains any PCL escape sequences introduced after PCL4, the
sequences will be ignored.
Refer to DECprint Supervisor for OpenVMS User’s Guide for information about
using the stapling option from DCPS.
5.2 DCPS Version 1.8 Fixes
The following problems are fixed in DCPS V1.8.
DCPS Version 1.8 Information 5–1