Technical data

1.1.3 Installation Procedure Changed
When installing DCPS when no previous DCPS version is installed, the
installation procedure asks about the location for layup files. Previously, if
the default location was accepted, the procedure would indicate the directory
did not exist and ask if it should be created. Since this directory will always
be created regardless of the answer to the question, the installer will no longer
be told the directory does not exist and will no longer be asked if it should be
created. The installer will continue to be asked about creating the directory if the
default location is not chosen.
1.1.4 Tray Names Added
The front input tray on the GENICOM LN28 printer can now be selected with
the name MULTIPURPOSE in addition to the name FRONT.
Input tray 1 on the HP LaserJet 4000 and 4050 printers can now be selected with
the name MULTIPURPOSE in addition to the name TRAY_1.
1.2 DCPS Version 2.0 Fixes
The following problems are fixed in DCPS V2.0.
1.2.1 Output Trays Not Selectable
With DCPS V1.8, it was not possible to select output trays on the Lexmark Optra
S 1855 and the Tektronix Phaser 780 printer.
1.2.2 PCL Translator Character Incorrect
When using the Swedish/Finnish character set, the DCPS PCL translator would
print the ’å’ character incorrectly as ’á’.
1.2.3 Help File Incomplete
With DCPS V1.8, part of the online help about Lexmark printers was missing
from the help file.
1.2.4 IVP Fails with ODS-5 Extended File Parsing
If the installation process was running with ODS-5 file parsing (SET
PROCESS=EXTENDED), the DCPS IVP would fail.
1–2 DCPS Version 2.0 Information