User manual

DIGITAL LN15-DA Duplexing Unit User Manual 4

Before installing the duplex unit, prepare your printer.

• First turn power off.

• Disconnect the power cord from both printer and power outlet.

• Disconnect the interface cable from the printer.

• Remove the multi-function feeder (MFF).

• Remove the rear cover from the printer as follows:

1. Remove the screw securing the rear cover to the printer.

2. Bending the left side of the rear cover, remove the cover.

3. Remove the rear stacker sliding along the guide grooves in the

printer. Be sure to store the rear stacker for future use.

4. Return the rear cover to the printer.

It is not necessary to change the printer location, but remember the

following:

Caution:

To avoid possible personal injury or harm to your equipment,

cooperate with another person in assembling or disassembling the

printer, duplex unit, multi-function feeder, and paper feeder (if

installed). Do not lift or move the printer as equipped with other units.

Notice:

Be sure to keep the rear opening of the duplex unit away from a wall

or another equipment so as to open the rear unit for clearing paper

jam or not to block the reverse operation of paper that comes out

and in the opening during two-sided printing.

To install the duplex unit, follow these steps:

1. Move the printer to clear its location and put the duplex unit

instead with the rear unit open.

Then, positioning the holes at the bottom of the printer to the

guide studs on the duplex unit, put the printer gently on the

duplex unit.

Preparing the

Printer

Installing the

Duplex Unit

☞