User manual

DIGITAL LN15-DA Duplexing Unit User Manual 7

Using the Rear Stacker

The rear stacker of the duplex unit has the same function with that

of the printer.

1. Open the rear stacker of the duplex unit.

2. Raise the paper support wire.

3. Set the paper path select lever forward the printer. Be sure to

move the lever all the way until it is stopped.

Notice:

After printing, be sure to return the paper path select lever backward

the printer.

Removing the Duplex Unit

When removing the duplex unit from the printer, follow these steps:

1. Turn the printer power off and remove the power cord, interface

cable, and multi-function feeder (if installed) from the printer.

2. Open the rear unit of the duplex unit.

3. Lift the printer to separate it from the duplex unit.

Caution:

To avoid possible personal injury or harm to your equipment,

cooperate with another person in lifting the printer. Do not lift or

move the printer as equipped with other units.

4. Store the duplex unit flat using the packing materials saved at

installation

5. Re-install the rear stacker in the printer.

6. Return the rear cover to the printer.

☞