Installation guide

8 Installation Guide DIGITAL Laser Printer LN15
5
Remove the restraint card board and
tape from the media cassette.
6
Close all covers and place the printer in
the location where it is to reside.
2.2. INSTALLING THE DUPLEXING UNIT (optional)
If you did not purchase the optional
duplexing unit, please proceed with the next
chapter (‘
PLACE THE PRINTER’
). If you
purchased the optional duplexing unit, at this
point you should first install the unit. Please
refer to the next drawing.
1.
The duplexing unit comes in a separate box. Unpack the box and place
the duplexing unit on a flat surface.
NOTE The duplexing unit has a base part and a
rear part, connected by a joint. When lifting the
duplexing unit, always hold it by the transport
grips of the base part and at the same time support
the rear part.
2.
Remove the rear printer cover by
removing one screw with a Philips type of
screwdriver. Be careful not to loose the
screw.
DIGITAL
Laser Printer LN15P
Duplexing Unit
Lower Media Tray