Installation guide

Installation Guide DIGITAL Laser Printer LN15 21
1
Open the duplexer rear stacker.
2
Open the metal paper support from
inside the stacker.
3
Set the paper path selector lever to
the stacker position ‘
B
’ (‘
A
’ is the
duplexer position).
NOTE Setting the paper path selector to the stacker
position ‘B’ and not opening the stacker, will always
result in a paper jam.
2.11. CONNECTING THE POWER CORD
1
Plug the female end of the power
cord in the connector on the rear
of the printer. Plug the opposite
end of the power cord in a
grounded AC outlet.
2
Turn the printer on (press down
the ‘|’ side of the switch). After a
brief warm-up (less than 2
minutes) the printer is ready.
2.12. PRINT A TEST PAGE
At this point you have set up your printer. It is recommended to do a simple test to
verify your setup. As soon as the message window on the control panel displays
‘READY’, press the following keys:
1. Press ‘
READY
’ (the online LED goes off).
2. Press ‘
SELFTEST
’ for more than 5 seconds.
After a while, the printer prints a status report.