Installation guide

Installation Guide DIGITAL Laser Printer LN15 11
2.
On the left side
of the tray, set
the lock lever to
the open
position (see
drawing, position
‘
B
’).
3.
Make sure that the rear part of the duplexing unit is locked properly. Lift
the printer and duplexing unit by the transport grips of the duplexing unit.
Carefully put it on top of the lower media tray, by inserting the two guide
pins into the two holes at the bottom of the duplexing unit. The most
convenient way is to perform the installation from the front side.
4.
Put the lock lever in the closed position (see drawing, position ‘
A
’). The
lower media tray is now physically attached to the upper part.
5.
Remove the restraint card board and
tape from the media cassette.
2.4. PLACE THE PRINTER…
• Away from cooling and heating sources, extreme temperature changes, direct
sunlight, excessive dust, corrosive chemicals or vapors, any strong
electromagnetic field, items that can easily burn and excessive vibration.
• In an area with a temperature range of 10 - 35°C and relative humidity range of
15% - 85%.
• On a hard level surface, capable of supporting the printer.
• Near your computer in case you use the parallel connection.
• Close to a grounded power supply of the rated line voltage.
• In a well-ventilated room.
• With enough space to allow adequate ventilation and easy servicing of the
printer.