Installation guide

10 Installation Guide DIGITAL Laser Printer LN15
7.
Close the duplexing
unit until the lock
lever clicks in place.
Note that the paper
path selector lever
has two positions :
‘
A
’ is the stacker
output position and
‘
B
’ is the duplexer
position.
NOTE You cannot close the duplexing unit, unless
the paper guide is pushed down in the locked
position. Carefully check before attempting to
close the unit.
NOTE Try to push the paper path selector. If it
does not stay in the stacker position, please
verify if the transport tape inside (just under the
lock lever) was removed. If not, please remove it
now and test again. For normal printing,
always set the paper path selector in the duplexer
position (‘B’).
8.
If you purchased a lower media tray, please proceed with the next
chapter. Otherwise proceed with the chapter : ‘
PLACE THE PRINTER
’.
2.3. INSTALLING THE LOWER MEDIA TRAY (optional)
If you purchased the lower media tray, at this
point you should install it now. Please refer
to the next drawing.
1.
The lower media tray is shipped in
a separate box. Unpack the box
and remove all protective covering
and tape. Put the lower media tray
on a flat surface.
DIGITAL
Laser Printer LN15P
Duplexing Unit
Lower Media Tray