Specifications

Precautionary Measures to be taken while Wiring the Circuit:
Turn OFF the power to the circuit, when wiring the circuit. Connecting
or removing measurement cables while the power is turned ON is
dangerous.
Take special caution not to wire a current measurement circuit to the
voltage input terminal or vice-versa.
Strip the insulation cover of the measurement cable so that when it is
wired to the input terminal, the conductive parts (bare wires) do not
protrude from the terminal. It is recommended to use appropriate pre
lug after crimping the wire. Also, make sure to fasten the input
terminal screws securely so that the cable does not come loose.
Use cables with safety terminals that cover the conductive parts for
connecting to the voltage input terminals. Using a terminal with bare
conductive parts is dangerous if the terminal comes loose.
After connecting the measurement cable, attach the current input
protection cover for your safety. Make sure that the conductive parts
are not exposed from the protection cover.
Use the suitable star screw driver and apply optimum torque to
prevent damage to the meter terminals.
CAUTION :
During normal operation of this instrument,
hazardous voltages are present at the rear terminals, which can cause
severe injury or death. These voltages are present throughout the
potential transformer (PT), current transformer (CT) auxiliary supply,
communication & Input / Output terminal. Installation, disconnection or
removal of the meter should be carried out only by qualified, properly
trained personnel, after de-energizing connected circuits. Improper
installation, including improper wiring and/or improper grounding will
void ElMeasure's warranty.
3