Specifications

21
11. Installation Procedure
Note : Connections to the terminals
located at the rear side of the unit is
to be made by using preferably 12 to
2 2
14 SW G ( 2. 6m m to 2. 6m m )
industrial grade wire. Relay rating No
contact SPST. 250VAC / 30VDC @ 2
Ampsresistive.
Connection Diagram for Little Genius Plus / Digital Output and RS 485
RS485
Common
Relay 1
Common
Relay 2
Connection Diagram:
The warnings, cautions & notes specified in this guide shall be followed
strictly (see the all pages).
The specified safety regulations must be observed.
Use dedicated fuse or circuit breaker in the Voltage and auxiliary circuit
in all the elmeasure make meters for the safe operation.
Fuse shall be used after PT.
Fuse / circuit breaker is not part of the instruments (refer rare side of
the TB Label). Recommended to use by the customer for safety
requirements.
Safety Requirments:
Connection
from AMF
panel to
Changeover
EB/DG