Instruction manual

4–26
Adjustment Procedures
10. Press B. “Printer Tests / Shift Recycle” displays.
11. Press A until “Printer Tests / Phase Printer” displays.
12. Press ENTER. The top line of the display will show “Phase Printer” and
the bottom line will show the current phasing index value.
13. Press ENTER. The phasing index value (followed by an asterisk) will
move up to the top line of the display. The printer begins printing all Hs,
each line preceded by the phasing index value.
14. Press " or A to increase or decrease the phasing index value, then press
ENTER to activate the value as it prints. Continue to increase or
decrease the phasing index value until the pattern of Hs appears as shown
below:
Needs
Adjustment
Correct
Needs
Adjustment
15. When the print pattern is acceptable, press ENTER. Printing stops, and
the printer automatically enters the current phasing index value into
NVRAM.
16. Press Y + B. “ENTER SWITCH LOCKED” briefly displays.
17. Close the printer cover.
18. Press the ON LINE key to place the printer online.
NOTE: If you changed the phasing value, power down the printer, remove
the shuttle cover, and write the new phase value on the aluminum
shuttle casting.