Instruction manual

4–10
Adjustment Procedures
Paper Scale Alignment (Figure 4–4)
1. Load paper and ribbon.
2. Connect the power cord to the AC power source.
3. Set the printer power switch to 1 (on).
4. Open the printer cover.
5. Verify that the shuttle cover (1) is properly installed (page 5–16).
6. Print a full 132 column line by selecting and running one of the
diagnostic self–tests. (See Chapter 4.)
7. Check alignment of the scale to the print at column positions 1 and 132.
8. If adjustment is necessary, loosen the three button–head 5/64 inch hex
screws (2).
9. Position the scale (3) so that column positions 1 and 132 line up with the
first and last characters on the 132 character printout.
10. Tighten the button–head screws (2).
11. Close the printer cover.