Instruction manual

4–3
Adjustment Procedures
Returning the Printer to Normal Operation
When you have finished servicing the printer, restore it to operation by
following the steps below:
1. Install the ribbon.
2. Plug the AC power cord into the printer and the power source.
3. Set the printer power switch to | (on).
4. Load paper.
5. Close the cabinet doors and the printer cover.
6. Test printer operation by selecting and running one of the diagnostic
print tests. (See Chapter 3.)
7. Select the emulation. (Refer to the Operator’s Guide or the Setup Guide.)
8. Set the top–of–form. (Refer to the Operator’s Guide or the Setup Guide.)