Instruction manual

7Index
paper path, 5–29
platen, 5–30
platen interlock switch assembly, 5–48
platen open belt, 5–7
platen open motor, 5–25
power supply circuit board, 5–12
resistors, terminating, 5–35
ribbon drive motor, 5–27
ribbon guide assembly (L/R), 5–37
ribbon hub, 5–38
shuttle cover assembly, 5–16
shuttle frame assembly, 5–42
splined shaft, 5–39
support shaft, 5–41
tractor (L/R), 5–50
RESETTING . . . / PLEASE WAIT, 4–31
Resistors, terminating, location of, 5–36
RESTORING BOOT CODE, 4–31
RIB INVLD CMD *, 3–8
RIB INVLD STATE *, 3–8
Ribbon
drive motor, replacement, 5–27
guide assembly (L/R), replacement, 5–37
guide assembly, alignment, 4–16
hub, replacement, 5–38
mask, replacement, 5–15
specifications, B–2
RIBBON DRIVE, 3–8
S
Safety
notices, 1–6
notices, defined, 1–3
Scheduled maintenance, 2–1
SECURITY CODE VIOLATION, 4–31
Security PAL, location, 5–22
SECURITY VIOLATION, 3–8
Self–tests
diagnostic, printer, 3–35
operator print, 3–35
SENDING PROGRAM TO EC
PROCESSOR, 4–31
Services. See Preventive Maintenance Checks
and Services
SET TOF key, 1–8
Shaft
splined, replacement, 5–39
splined, skew adjustment, 4–18
support, replacement, 5–41
SHUTL INV CMD *, 3–8
SHUTL INV PARM *, 3–8
Shuttle
cover assembly, replacement, 5–16
frame assembly, replacement, 5–42
SHUTTLE JAM, 3–8
Signal mnemonics, E–1
SIMMs, location and replacement, 5–21
Software, loading into flash memory, 4–27
SOFTWARE ERROR *, 3–8
Specifications
dimensions, printer, B–4
duty cycle, B–2
electrical, B–5
environmental, B–4
interfaces, B–6
paper, B–3
printing rates, B–7
ribbon, B–2
Speed, printing, B–7
Splined shaft
replacement, 5–39
skew adjustment, 4–18