Instruction manual

1–8 Maintenance Overview
Controls and Indicators
Electrical Controls and Indicators (Figure 1–1)
Switch or
ON LINE
LCD
LF
Function
Indicator
Status Lamp
FF
VIEW
Offline: displays next higher level of configuration menu.
Online: moves paper up in 1/72 inch increments.
R/S
ENTER
Displays previous parameter in a configuration or
diagnostic test menu.
On when the printer is online, off when printer is offline.
Flashes to indicate a fault or warning.
Runs and stops configuration and self tests. Runs and
stops hex dump. Makes a configuration printout when
pressed with “OFFLINE/CONFIG. CONTROL” displayed.
Enters displayed parameter into printer nonvolatile
memory. Must be unlocked before using.
Clears fault message from LCD after a fault is corrected
and returns printer to off–line state. CLEAR + ENTER
cancels a print job by flushing data from the print buffer.
Clears “PLATEN OPEN” open fault message.
Displays next parameter in a configuration or diagnostic
test menu.
Advances paper for viewing through cover window, then
returns paper to print position.
CLEAR
SET TOF
Sets location of first line of print on a page.
Y
"
B
A
Turns printer on and off: 1 = on, 0 = off. This switch is also
a circuit breaker.
Power Switch
(UP)
(DOWN)
(PREV)
(NEXT)
+ YB
Locks and unlocks the ENTER key.
Liquid Crystal Display. Displays printer status and error
messages.
Offline: displays next lower level of configuration menu.
Online: moves paper down in 1/72 inch increments.
“CANCEL DATA” command. Electrically clears the print
buffer (no printout) and sets TOF at current position.
Advances paper to top of form on next page.
Advances paper to top of next print line.
Toggles the printer online and offline.
Active when printer is:
Online Offline
nn
nn
n
n
n
n
n
n
n
n
n
n
n
n
n
n
CLEAR + ENTER
n