Instruction manual

5–49
Replacement Procedures and
Illustrated Parts List
Installation
1. Fully close the forms thickness lever (position ‘A’).
2. Position the platen interlock switch assembly on the switch bracket and
install the two #1 Phillips screws securing it to the bracket. (See
Figure 5–14, page 5–67.)
3. Route the switch cable through the cutout in the right side plate and to
the controller board. (See cable routing diagram on page A–10.)
4. Connect the platen interlock switch cable to the connector shell P107
(see page 5–8), then connect the connector shell to the controller board.
5. Install the paper path (page 5–29).
6. Return the printer to normal operation (page 4–3).