Instruction manual

5–47
Replacement Procedures and
Illustrated Parts List
Installation
1. Holding the slotted wheel against the PMD sensor, position the paper
detector switch assembly and install the screws securing it to the printer
base. (See Figure 5–15, page 5–69, item 4.)
2. Check PMD sensor arm range: make sure it travels freely and completely
back into the sensing cavity.
3. Route the switch cable back to the controller board, installing the cable
in the restraints under the base casting. (See cable routing diagram on
page A–10.)
4. Connect the paper detector switch cable to the connector shell (page
5–8), then connect the connector shell P106 to the controller board.
5. Install the barrier shield and tighten the four screws. (See page 5–59,
Figure 5–10, items 3, 4, and 9.)
6. Install the paper path (page 5–29).
7. Check and adjust the End of Forms Distance (page 4–20).
8. Return the printer to normal operation (page 4–3).