Instruction manual

5–41
Replacement Procedures and
Illustrated Parts List
Shaft, Support
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Unlock the tractors and slide them to the far right.
4. Remove the E–ring (page 5–65, Figure 5–13, item 17).
CAUTION
Hold the tractors while removing the support shaft, and be careful not to
lose the two curved spring washers. (See Figure 5–13, page 5–65, item 5.)
5. Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer and
screw—to the left, out of the tractors and the left side plate. (See
Figure 5–13, page 5–65, items 1 through 5 and 15.)
Installation
1. Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer, and
screw—into the left side plate. (See page 5–65, Figure 5–13, items 1
through 5 and 15.)
2. Slide the tractors onto the support shaft.
3. Slide the support shaft assembly through the right side plate.
4. Push the horizontal adjustment knob to compress the curved washers and
install the E–ring in the groove on the support shaft.
5. Return the printer to normal operation (page 4–3).