Instruction manual

5–34
Replacement Procedures and
Illustrated Parts List
Platen Installation (continued)
18. Install the platen shaft pulley with the 7/64 inch setscrew facing up and
tighten the setscrew. Open and close the forms thickness lever and check
that the platen pulley setscrew does not hit the left ribbon guide.
19. Install, but do not adjust, the platen open belt and platen open motor
pulley (page 5–7).
20. Install the paper ironer with the black tape towards the rear of the printer
(page 5–28).
21. Install the shuttle frame assembly (page 5–42).
22. Adjust the platen gap (page 4–12).
23. Adjust the platen open belt (page 4–6).
24. Check ribbon guide alignment (page 4–16).
25. Check the hammer phasing (page 4–25).
26. Return the printer to normal operation (page 4–3).