Instruction manual

5–31
Replacement Procedures and
Illustrated Parts List
Installation
IMPORTANT
The dowel pins protruding from the ends of the platen are the platen
shafts, and are not equal in length. The platen must be installed with the
longer shaft
on the right side.
1. Wipe the platen shafts clean of grease and debris.
2. Install the washer on the longer platen shaft. (See Figure 5–3.)
Platen Shaft
(Right Side)
Washer
Ironer Bracket
Platen Adjust
Platen Bracket
Bushing
Bracket
Figure 5–3. Installation of Platen Adjust Bracket Bushing
3. Apply bearing lubricant to both platen shafts and to the inside surface of
the platen bracket bushings. (See Figure 5–3.)
4. Install the platen adjust bracket bushings as shown in Figure 5–3.
5. Make sure the two wear saddles are set flush into the corners of the
mechanism base platen seat. (See Figure 5–4.)