Instruction manual

5–29
Replacement Procedures and
Illustrated Parts List
Paper Path
WARNING
Unless directed to do otherwise, always unplug the printer from the
power source before performing a maintenance procedure. Failure to
remove power could result in injury to persons or damage to equipment.
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Loosen the three paper path hold–down screws (page 5–59, Figure 5–10,
item 6).
4. Slide the paper path to the left and lift it off the card cage.
Installation
1. Position the paper path offset slightly to the left on the card cage with the
keyway cutouts over the three loosened hold–down screws (page 5–59,
Figure 5–10).
2. Slide the paper path to the right, engaging the three hold–down screws in
the keyway slots. Slide the paper path to the right as far as it will go.
3. Tighten the three hold–down screws (page 5–59, Figure 5–10, item 6).
4. Return the printer to normal operation (page 4–3).