Instruction manual

5–28
Replacement Procedures and
Illustrated Parts List
Paper Ironer
WARNING
Over time, the upper edge of the paper ironer can become sharp. To
avoid cutting yourself, handle the paper ironer on the sides.
Removal
1. Remove the shuttle frame assembly (page 5–42).
2. Move the forms thickness lever to the open position.
3. Push the ends of the paper ironer toward the rear of the printer, disengage
the tabs, then lift it up and out (page 5–67, Figure 5–14).
Installation
NOTE: The black tape on the paper ironer faces the paper detector switch
assembly.
1. Position the paper ironer so that the black tape is on the side that faces
the paper detector switch assembly. (See page 5–67, Figure 5–14.)
2. Push the paper ironer down into the slots until the tabs engage.
3. Install the shuttle frame assembly (page 5–42).
4. Return the printer to normal operation (page 4–3).