Instruction manual

5–27
Replacement Procedures and
Illustrated Parts List
Motor Assembly, Ribbon Drive
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Remove the ribbon.
3. Remove the ribbon hub (page 5–38).
4. Remove two screws and washers securing the ribbon drive motor to the
base casting (page 5–61, Figure 5–11).
5. Lift and rotate the ribbon drive motor until the motor cable is aligned
with the slot on the base casting.
6. Disconnect the ribbon drive motor cable connector.
Installation
1. Reverse steps 3 through 6 of the removal procedure above.
NOTE: The ribbon drive motor should be secured at the front right and rear
left corners. (See Figure 5–15, page 5–69.)
2. Return the printer to normal operation (page 4–3).