Instruction manual

5–23
Replacement Procedures and
Illustrated Parts List
Motor Assembly, Paper Feed
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Remove the paper path (page 5–29).
4. Loosen four screws and remove the barrier shield (page 5–59,
Figure 5–10).
5. Remove the timing belt cover by squeezing the top and bottom to release
the plastic tabs from the slots in the side plate (page 5–59, Figure 5–10).
6. Loosen, but do not remove, the two 5/16 inch paper feed motor mounting
bolts (page 5–69, Figure 5–15).
7. Loosen the 7/64 inch shaft collar setscrew and remove the paper feed
motor pulley, shaft collar, and paper feed timing belt (page 5–69,
Figure 5–15).
8. Trace the paper feed motor cables back to the controller board, releasing
the cables from the tie–wraps. (See cable routing diagram on page
A–10.)
9. Disconnect connector shell P107 from the controller board.
10. Remove the paper feed motor cable connector from the connector shell
(page 5–8).
NOTE: Some motors are mounted with nuts and bolts; other motors have
threaded flanges, eliminating the need for nuts.
11. Remove the motor mount bolts (and nuts, if present).
12. Remove the paper feed motor assembly.