Instruction manual

5–14
Replacement Procedures and
Illustrated Parts List
Control Panel Assembly
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Disconnect RJ11 connector P310 from connector J310 on the control
panel.
4. Loosen the four screws securing the control panel to the control panel
bracket. (See Figure 5–9, page 5–57.)
5. Remove the control panel assembly from the keyways in the control
panel bracket.
Installation
1. Position the control panel assembly on the bracket, engage the mounting
screws in the keyways, and hand tighten the screws. (See page 5–57,
Figure 5–9.)
2. Connect RJ11 connector P310 to connector J310 on the control panel.
3. Lower the printer cover and center the control panel assembly in the
cutout of the printer cover.
4. Open the printer cover and tighten the four control panel mounting
screws.
5. Return the printer to normal operation (page 4–3).