Instruction manual

5–13
Replacement Procedures and
Illustrated Parts List
Circuit Breaker
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Remove the paper path (page 5–29).
4. Remove the card cage fan (page 5–17).
5. Disconnect the four circuit breaker electrical leads. (See page 5–71,
Figure 5–16.)
6. Press in on the spring clips and remove the circuit breaker from the
printer.
Installation
1. Press the circuit breaker into the cabinet wall until the spring clips snap
into place. (See Figure 5–16, page 5–71.)
CAUTION
To prevent severe damage to the printer, the circuit breaker electrical
leads must be connected as shown on page 5–71 (Figure 5–16).
2. Connect the four circuit breaker electrical leads as shown on page 5–71,
Figure 5–16.
3. Install the card cage fan (page 5–17).
4. Install the paper path (page 5–29).
5. Return the printer to normal operation (page 4–3).