Instruction manual

5–11
Replacement Procedures and
Illustrated Parts List
Installation
CAUTION
To prevent electrostatic damage to electronic components, always wear a
properly grounded static wrist strap when you handle circuit boards.
1. Position the controller board in the card cage, shield side down,
component side up. Engage the screw on the bottom of the card cage in
the keyway in the controller shield. Slide the board to the right until the
hole in the side of the controller shield lines up with the hole in the card
cage. (See page 5–61, Figure 5–11, item 13.)
2. Tighten the two screws securing the controller shield near serial cable
connector J201.
3. Tighten the screw securing the controller shield to the bottom of the card
cage.
4. Connect all cable connectors to the controller board, using the
Interconnection Diagram on page A–2 as your guide.
5. Install the paper path (page 5–29).
6. Adjust the hammer phasing (page 4–25).
7. Adjust the end of forms distance (page 4–20).
8. Return the printer to normal operation (page 4–3).
9. Using the configuration printout you made as step 1 of the removal
procedure, reset and save the printer configuration.