Instruction manual

5–8
Replacement Procedures and
Illustrated Parts List
Cable Connectors and Connector Shells
Some of the printer cable connectors are grouped inside connector shells.
The procedure below explains how to remove and install cable assemblies
from any connector shell in the printer.
NOTE: There is also a diagram of the P106 / P107 connector shells on the
plastic heat shield over the power supply.
Removal
1. Remove the paper path (page 5–29).
2. Disconnect the cable connector shell containing the cable assembly that
will be replaced.
3. Pull the side of the connector shell outward and gently pull the cable
connector upward. (See Figure 5–1.) Notice that two–wire connectors are
grouped across from two–wire connectors in a connector shell.
Four–wire connectors are grouped across from four–wire connectors in a
connector shell.
4. Disengage the key tab(s) on the cable connector from the slots in the side
of the connector shell.
5. Remove the cable connector from the connector shell. (Remove only the
cable connector for the cable you are replacing; leave the rest in the
shell.)
Installation
1. Position the cable connector in the connector shell. Two–wire connectors
are always grouped across from two–wire connectors in a connector
shell. Four–wire connectors are always grouped across from four–wire
connectors in a connector shell. (See Figure 5–1.)
2. Pull the side of the connector shell outward and gently push the cable
connector down into the connector shell.
3. Engage the key tab on the cable connector in the slot in the side of the
connector shell. Press the sides of the connector shell inward to make
sure all cable connector tabs are engaged in the shell slots.
4. Connect the cable connector shell to its printer connection.
5. Install the paper path (page 5–29).