Instruction manual

5–5
Replacement Procedures and
Illustrated Parts List
Belt, Paper Feed Timing
Removal
1. Prepare the printer for maintenance (page 4–2).
2. Open the printer cover.
3. Remove the paper path (page 5–29).
4. Remove four screws, the barrier shield, and the anti–static brush (page
5–59, Figure 5–10).
5. Remove the timing belt cover by squeezing the top and bottom to release
the plastic tabs from the slots in the side plate (page 5–59, Figure 5–10).
6. Loosen (do not remove) the 7/64 inch setscrew in the paper feed motor
pulley collar.
7. Loosen (do not remove) the two 5/16 inch paper feed motor mount
screws (page 5–69, Figure 5–15).
8. Remove the paper feed timing belt by sliding the paper feed motor pulley
off the motor shaft and the belt off the splined shaft pulley.