Instruction manual

4–31
Adjustment Procedures
Message
Required
Action
Explanation
ERROR: WRITING
TO FLASH
Hardware or software fault in flash
memory.
Download the
program again. Go
back to step 10. If
the message occurs
again, replace the
flash memory.
ERROR: WRONG
CHECKSUM
The printer received the complete
program but the checksum did not
match. The data were corrupted
during download.
Download the
program again:
Power off the printer
and start over at step
10.
LOADING PROGRAM
FROM PORT XX%
The new program is loading into
printer RAM. XX indicates how
much of the program has loaded.
None
LOADING PROGRAM
INTO FLASH
The printer has deleted the previous
program from flash memory and is
loading the new program into flash
memory.
None
RESETTING . . .
PLEASE WAIT
The printer finished loading the
program into flash memory and is
automatically resetting itself.
None
RESTORING
BOOT CODE
Normal download initialization
message.
None
SECURITY CODE
VIOLATION
The software running or being
downloaded does not match the
security PAL code.
Install the correct
PAL or program.
(PAL and program
must match.)
SENDING PROGRAM
TO EC PROCESSOR
The printer is loading the engine
controller program into the engine
controller.
None