Instruction manual

4–28
Adjustment Procedures
8. Make the diskette drive the active drive by typing the following at the
DOS prompt:
A:<return>
(If the diskette is in drive B, type B:<return>)
9. Get the name of the compressed file on the diskette by listing the
contents of the diskette; at the DOS prompt type:
DIR<return>
The compressed file on the diskette takes the form
FILENAME.EXE
Write down the complete name of the file with the .EXE extension.
10. On the printer operator panel, press and hold down the ONLINE + FF
keys. Without releasing the keys, power the printer on. Continue holding
the keys down until “WAITING FOR PROGRAM DOWNLOAD”
appears on the LCD.
11. When you see “WAITING FOR PROGRAM DOWNLOAD” on the
LCD, release the ONLINE + FF keys.
12. At the DOS prompt on the computer type:
FILENAME.EXE –pb<return>
where FILENAME.EXE is the file you noted in step 9. This command
expands the file and copies it as a binary file into the flash memory on
the CMX controller board.
NOTE: If you are downloading the file using the LPT2 port on the PC, enter
the following DOS command:
FILENAME.EXE –pb 2 <Return>
If you are downloading the file into the printer serial port, enter the
following DOS commands:
MODE COM1:9600,N,8,1,P<Return>
FILENAME.EXE –PBC1<Return>
13. While the file is copied into memory, the printer LCD informs you of the
load process and status. (See Table 1.)
14. When the file has successfully loaded into memory and the printer has
reset itself, set the printer power switch to O (off).
15. Unplug the AC power cord from the printer.
16. Remove the diskette from the personal computer and store it with the
printer.