User guide

Reducing the Print Noise Level
To print with a reduced noise level (Quiet mode).
• Press the
Quiet
button.
The display shows Quiet instead of the current printer state.
To return to Normal mode:
• Press the
Quiet
button again.
The display shows printer state that was active before pressing the
Quiet
button.
Recovering from a Fault State
Recovering from a Paper out Fault
If the printer is out of paper, the
Fault
and
Ready
indicators are lit and the display shows the
Load X message, where X is the current Paper Path.
1. Make sure that paper is loaded in the current paper path.
2. Press the
FF/Load
button.
The display shows Loading... and paper is loaded.
Note:
If no paper is installed in the current Paper Path, see Chapter 3 "Handling Different
Paper Types" for the paper installation procedure.
Recovering from other Faults
To recover form any other Fault state:
1. Remove the cause of the Fault state.
2. Press the
Pause
button, to clear the Fault state.
Note:
It may happen, that two Fault states occur at the same time. In this case press the
Pause
button repeatedly, until both of them are cleared.
Operating Your Printer
4-6