User guide

Selecting the Font
The
Font
button allows you to select one of the following resident fonts:
Draft - HiDraft - Courier - Roman - Sans Serif - Prestige - Script - Orator - OCR-A - OCR-B
You can also select the SoftContrl (Software Control) Value. Software Control means that the
font that is used by the printer is defined through the commands of your software application.
This message blinks alternately with the Font that will be used if the printer receives no software
command.
To select a resident font:
1. Press the
Font
button.
2. Within 3 seconds press the
Font
button, until the desired font is displayed (keeping the button
depressed displays the different fonts continuously.
Three seconds after releasing the button, the display shows the basic screen again and the font
is set.
Note:
- If a font is selected using the
Font
button, it is locked and cannot be changed by
software commands. The basic screen then shows then the Lock symbol.
- The font selection made using the
Font
button is canceled as soon as you power-off the
printer.
To return to Software Control, press the
Font
button, until SoftContrl is displayed.
Operating Your Printer
4-4