User guide

Printing on Adhesive Labels
When printing on adhesive labels, use one of the straight paths, that is Push-Front, Pull or
Push+Pull. Do not use the Push-Rear path.
You must also disable the backward movement of the paper, because the unsticking of the labels
can cause paper jams when the paper is moved backwards.
Proceed as follows:
1. Press the
Set-Up
button to put the printer in Set-Up mode.
The display shows MACROS.
2. Press the button. MACRO X is displayed, where X is the number of the current Macro.
3. Press the button.
The display shows PROTOCOL.
4. Press the button until the TEAR/VIEW MODE Option is displayed.
5. Press the button to pass over to the Values for the Tear/View mode.
6. Press the or button, until No tear/reverse is displayed.
7. Press the
Sel/Save
button to set confirm the new setting. An asterisk is displayed to indicate
that the Value has been selected.
8. Press the
Exit
button to exit the Set-Up mode.
The message "Save config." appears, indicating that you are going to save your new
setting.
9. To permanently save your choice, press the
Sel/Save
button.
Note:
Is is not necessary to perform the above operation when using the Pull paper path, as all
backwards movements are inhibited with this path. We reccommend using the Pull path
when printing on adhesive labels, but note however that the printing of landscape
barcodes may generate backward movements.
Handling Different Types of Paper
3-37