User guide

How to Select a Paper Path
The selection of the paper path can be done using the printer driver with your application
software. There are also two ways of selecting the paper path operating on the printer.
– using the operator panel, to change the paper path temporarily for a specific need at a given
time
– using the Set-Up mode, to switch to a specific customized Configuration (Macro)
including the use of a dedicated paper path.
Using Set-Up Mode
The Set-Up mode allows you to manage the paper paths used at power-on. Using the PATH AT
POWER-ON Option, you can choose one of the two possibilities:
Path at Power-on Value Definition
From Macro
The paper path at power-on will be the paper path selected in the
active Macro at power-on. The corresponding PAPER PATH Option
is available in the Macro Option list only when this Value is selected.
Last sel. Path
The paper path at power-on will be paper path selected when the
printer was powered off.
If you select the From Macro Value, select the paper path you intend to use in the PAPER
PATH Option available in the Macro Option list. If the paper feeding device corresponding to
your Macro definition is not present at power-on, the display shows a specific message.
Note:
See Chapter 6 "Configuring Your Printer" for information about the PATH AT
POWER-ON Option and Chapter 7 "Customizing Macros" for information about the
PAPER PATH Option.
Handling Different Types of Paper
3-5