User guide

7. Press the
Sel/Save
button.
The display shows Initializing.... Once the initialization is complete, the display
shows again the SetUp Card init. message.
8. Press the
Exit
button.
Copying your Configuration to the Set-Up Card
1. Make sure the printer is powered off.
2. Insert the Set-Up Card into the slot and power the printer on.
The display shows the blinking message SET-UP CARD MODE for 5 seconds. Then the
display shows Printer << Card.
3. Using the or button, you can scroll between the following Values:
Value Definition
Printer << Card The contents of the card is copied into printer permanent memory.
Printer >> Card The contents of the printer permanent memory is copied onto the
card.
Access:Minimum This value has the same effect as the Minimum Value of the USER
ACCESS Function. Useful after copying the printer Configuration
from the Set-Up card. See also Chapter "Setting the User Access
Authorization" in Chapter 6.
4. Display the Printer >> Card Value.
5. Press the
Sel/Save
button.
The display shows Copying..., and the Printer >> Card Value is displayed again.
6. Press the
Exit
button.
The printer finishes its start-up sequence.
Supplies and Options
A-13