User guide
Table Of Contents
- Title Page
- Contents
- Preface
- 1.Introduction
- 2.Paper Handling
- 3.Printing
- 4.Set-Up Mode
- What is it for?
- How it works
- Entering set-up mode
- Overview of set-up mode
- Printing the configuration
- Deciding which options to change
- Changing Macro options
- Macro options list
- Changing install options
- Install options list
- Adjusting top-of-form origin
- Changing menu access options
- Exiting & saving
- Recalling factory settings
- Using diagnostic functions
- Quick reference for set-up mode
- 5.Maintenance
- 6.Troubleshooting
- A.Supplies & Options
- B.Specifications
- C.Command Sets
- D.Interface Information
- E.Character Sets
- F.Resident Fonts
- Glossary
- Index
- Standards Conformity
2-21
Paper Handling
4. Open the acoustic cover and the top cover e to access the top of the printer.
5. Position the catches q of the tractor unit on the support studs r near the platen shaft.
A. Push the forms tractor unit toward the front of the printer.
B. Snap down the tractor unit into place so that the catches click on the rear studs.
Installing the Tractor Unit for Pull-tractor Feed
6. Turn the platen knob to make sure that the tractor gear fully engages the platen shaft
gear. Lean the top cover and the acoustic cover against the tractor unit.
The following are the procedures to take when you want to feed continuous forms paper
from under the printer (bottom feed).
To load continuous forms paper:
1. Make sure that the bottom slot of the printer is adjusted with the slot of the desk or
printer rack.
2. Set the paper thickness lever to position D (widest gap).
3. Move the paper select lever to the rear (continuous forms).
q
r
e
K
A
K
B
#02 Chapter 2 23/05/96, 14:1721