User guide

PARAMS, Continued
STATUS
STATUS displays miscellaneous information such as module
configuration, history, current counters, and so forth, depending
on the type specified.
STATUS
Syntax
STATUS type
STATUS
Parameters
The type is the optional ASCII string that denotes the
type of data desired. You can also abbreviate type; an
abbreviation selects all types with matching names. If
omitted, all available data are displayed. The following
types are available:
CONFIG displays the module name, node name, power
on hours, power cycles, and other such configuration
information. Any unit failures as well as NVR failures
are displayed if applicable.
BB displays the bad block log for the device. A list of
physical blocks that have been replaced is given.
LOGS displays the last eleven (11) machine and bug
checks on the module. Included in each dump are the
M68000 registers (D0-D7, A0-A7), the time and date of
the failure (if not available, 17 November 1858 is used),
and a few hardware registers.
DATALINK displays the data link counters.
PATHS displays available path information (open VCs)
from the point of view of the controller. Included are
the remote node names, DSSI IDs, software type and
version, and counters for messages/datagrams sent
/received.
SYSTEM displays system statistics and counters.
Continued on next page
4–35