User guide

PARAMS, Continued
LOCATE
Example
The following appears on the screen when this command is
used:
PARAMS> locate
Drive has been soft faulted to help locate it
Press RETURN to continue:
PARAMS>
SET
Use the SET command to change the value of a given parameter
in the cached copy of the NVR image that is maintained
by PARAMS. The type and radix of the new value for the
parameter is determined by the type and radix of the parameter
itself ONLY and not by radix specifiers or quotes in your input.
ASCII parameters are left justified and blanks are padded into
their field width.
SET Syntax
SET parameter-name value
SET
Parameters
parameter-name is the name of the parameter you want
to change. If abbreviated, the first matching parameter
name is used without regard to uniqueness. In addition,
the character "." may be used to reference the previously
referenced parameter. If there is no previously referenced
parameter, an error message is displayed.
value is the value assigned to the parameter. The radix
and type is specified by the parameter and not by radix
specifiers or quotes. For example, the command SET NODE
SUSAN sets parameter NODENAME equal to SUSAN.
Continued on next page
4–32