User guide

Chapter 3
Controls and Indicators
Introduction
In this Chapter
This chapter describes the controls and indicators associated
with ISE operation. The controls and indicators are located on
the:
Operator control panel (OCP) on the system enclosure
ISE front panel (Figure 3–1)
Operator
Control Panel
(OCP)
The operator control panel (OCP) is a set of controls on the
enclosure that overrides the drive module switches and lets
you set the DSSI node ID and write-protect mode for the ISE.
The OCP also contains a fault LED that indicates if the ISE is
malfunctioning.
Continued on next page
3–1