User guide

Installing into the SF7X Enclosure, Continued
Installation
Steps
To install the ISE into the SF7X enclosure (Figure 2–5):
1. With the ISE skid plate facing the enclosure guide rails,
slide the ISE along the guide rails until the ISE is locked in
place inside the SF7X enclosure.
2. Use a Phillips head screwdriver to tighten the screws on
the wedges, so the ISE sets securely in the enclosure.
3. Take the three extension cables from the shipping box:
DSSI flat cable (50 conductor)
Front panel (Operator Control Panel (OCP)) cable (10
conductor)
Power cable (5 conductor)
4. Connect one end of each extension cable to the EF5XX ISE
and the other end of each extension cable to the cables
already attached (Figure 2–5) to the SF7X enclosure.
Continued on next page
2–13