User guide

Installing into the SF7X Enclosure, Continued
Inserting the
Wedges
To insert the wedges:
1. Remove the two wedges from the shipment box.
2. Hold one wedge at the front end (contains the screw) and
insert the two rear prongs into the two elongated holes on
the side of the chassis (Figure 2–4). The two holes are 2-3/4
inches from the rear of the chassis.
3. Lower the front end of the wedge and insert the front
prongs into the two circular holes next to the connectors on
the front of the drive (Figure 2–4).
4. Do the same steps to insert the other wedge on the opposite
side of the chassis.
Continued on next page
2–11