User guide

Installing into the BA400-Series Enclosure, Continued
Installation
Steps
To install the ISE into the BA400-series enclosure:
1. With the side that had the skid plate attached to it facing to
the right, slide the ISE along the guide rails into the mass
storage cavity (Figure 2–2A).
2. Using the upper and lower finger cutouts on the ISE
brackets, firmly push the ISE brackets until the interface
card at the rear of the ISE plugs into its backplane
connector. The guide tabs on the upper and lower brackets
should line up with the cutouts in the chassis. Tighten the
two captive screws (Figure 2–2A).
CAUTION
It is normal to have a small gap between the ISE
mounting bracket tabs and the enclosure frame.
Tighten the captive screws only until they are
securely fastened (9 inch-pounds). Do not try to
force the tabs to fit flush against the frame.
3. Plug the remote front panel cable(s) into the connector(s)
inside the ISE front panel (Figure 2–2B).
Use Velcro on the cable and on the inside of the ISE front
panel to secure the remote front panel cable.
4. Attach the ISE front panel to the enclosure by first fitting
the panel’s lower tabs into position. Fit the panel into
position and secure the panel with its single captive Phillips
screw (Figure 2–2D).
Continued on next page
2–5