User guide

Installing into the BA400-Series Enclosure
Preparing
for the
Installation
To prepare for the installation:
CAUTION
Static electricity can damage integrated circuits.
Use the antistatic wrist strap and antistatic pad
found in the static-protective field service kit
(29-26246-00) when you work with the internal
parts of a computer system.
Handle the ISE with care. Dropping or bumping the
ISE can damage the disk surface.
1. After the system manager shuts down the operating system,
set the lock of the enclosure to the bottom position to open
both the top and bottom enclosure doors.
2. Set the enclosure power switch to off (0).
3. Always install ISEs working from right to left.
NOTE
The first or rightmost mass storage cavity in
the mass storage area is wider than the rest to
accommodate a larger device such as a tape
drive. A small filler panel (70-27414-01) is used
to fill the gap when an EF5XX ISE is installed in
this first cavity.
4. Loosen the captive Phillips screw at the top of the blank
ISE front panel assembly and remove the panel.
Before installing an EF5XX-series ISE into a BA400-series
enclosure, you must first remove the skid plate, explained in
the next section.
Continued on next page
2–2